This Version of Internet Explorer Is Not Supported

We recommend you upgrade to a more modern browser.

Some options are Google Chrome and Firefox.
1.While at the device location, point your remote at the device. Press and hold the device mode button on your remote.

All four mode buttons should light up

2.Press the receiver POWER button on your DISH remote

The device button should light up

3.Press the UP or DOWN arrow on the remote (about one press per second). During the scan, the mode light will remain lit when you are not pressing the up or down arrow, but will go out each time the arrow is pressed. Stop as soon as the device turns off, and proceed to step #5. This process may take several minutes.

The TV should turn off

4.If the scan has cycled through all available codes, the mode light will blink rapidly for two seconds, and will light up only when you press the up or down arrow. This may take approximately 5 minutes. If the scan fails to produce a code that will control the device, advise the customer that Dish does not currently support the equipment.
5.Press the POUND (#) button

The device Mode button should flash 3 times

6.Press the POWER button on your remote to turn the device on. If this does not work, return to step 1.

If you have already completed the scan more than once, and are still unable to address the remote, advise the customer that the code that controls their equipment is not in the Dish remote.
The device should turn on and respond to remote commands


Get Remote Codes Currently In Use

6.Press and hold the TV mode button on the remote until all four mode buttons at the top of your remote light up


7.Press the POUND (#) button twice


8.The mode light flashes the number for each digit of the device code, with a pause between the groups of flashes. A quick flash is for zero.
Example: The mode light flashes five times, pauses, flashes seven times, pauses, and flashes once quickly for the 570 code.