Hopper/Joey/922

Program Remote to Receiver

1.	Press the SYSTEM INFO button on the front of your receiver	The "System Info" screen should display
2.	Press the SAT mode button on your remote	The SAT mode button should light up and you should hear a series of beeps
3.	Press the CANCEL button	The "System Info" screen should close and programming should display
4.	Go to the TV where the remote will be used. Press the GUIDE button.	The programming guide should display on the TV

1.	Press the SYSTEM INFO button on the front of your receiver	The "System Info" screen should display
2.	Select Un-Link and press the SELECT button on the front of your receiver	If deprogramming is successful, 3 decreasing tones should be heard from the remote

1.	Press and hold the SAT mode button	The SAT mode button will begin blinking
2.	Press and hold the RECALL and 0 (System Wizard) buttons at the same time for 3 seconds
3.	Press the SEARCH button
4.	Press the VOL + button
5.	Press the STOP button, then wait 5 seconds	If deprogramming is successful, 3 decreasing tones should be heard from the remote