Expand
Powerline Phone Connector
Was this page helpful?


SUBMIT

On-Screen Setup Non-922

After physically connecting the Powerline Phone Connector into the receiver, follow these instructions to properly configure
 

Configure Powerline Phone Connector

1.Press the MENU button on the remote
 
2.Select "System Setup"
 
3.Select "Installation"
 
4.Select "DishCOMM Setup"
 
5.Select "Scan"


 
6.The receiver will send a signal via the electrical wiring in the home
 
  1. If a Powerline Phone Connector does not respond, the "DishCOMM Setup" screen will only display the current receiver



  2. If a Powerline Phone Connector responds, "Attention 964" asks to add it to the network. Only one Powerline Phone Connector may be added. To add the current connector, select "Yes." To select another connector, select "No."


     
7.Receivers on the same account with a Powerline Phone Connector built in will also respond, and are added automatically. Select "Done."


 

Test Powerline Phone Connection

1.Press the MENU button on the remote
 
2.Select "System Setup"
 
3.Select "Installation"
 
4.Select "DishCOMM Setup"
 
5.Select "Test"


 
6.The receiver will test the connection to and from other Powerline Phone Connectors. Results are displayed in the "Local" (To), and "Remote" (From) fields.

Test ResultSpeed
None<1 Mbps
Poor1 Mbps
Good2-7 Mbps
Exlt8-12 Mbps

  1. If the connection has failed, the Local/Remote (To/From) field will display "None (00)"


     
  2. If the Powerline Phone Connector is connected, select "Done"