Change UHF Band - 6 Remote

Use a different UHF load to prevent interference from other remotes using the same UHF band frequency.

1.Remove the battery cover from your remote


 

2.Use the tip of a pen to move the switch located next to the battery compartment from the A position to the B position


 

3.Replace the battery cover


 

4.Press the SYSTEM INFO button on the front panel of your receiver. Avoid accessing the "System Info" screen using the remote, as this could cause re-addressing on both impacted remotes.


 
The "System Info" screen should display





 
5.Press the RECORD button on the remote



 
The number entered in Step 4 should display in the "System Info" screen


 
6.Select "Done"



 
The "System Info" screen should close and programming will display